Homebrew PCBs

Hi Zoran
Just had a look at the Proxxon TBM 220
It's top speed is only 8500 rpm, is this speed
any good for tungsten carbide bits ?

Howard 

--- In Homebrew_PCBs@yahoogroups.com, "Zoran A. Scepanovic" <zastos@...> wrote:
>
> On 15-May-12 14:43, Howard wrote:
> > Hi All
> > Am having some probs with my drill\stand setup.
> > 
> > The stand is the type with a single slide piller,
> > it is meant for a 240v work drill (i use a dremel drill )
> > sometimes the stand will move from side to side and 
> > snap the drill bit !!.
> > 
> > Can anyone suggest a good drill\stand combination, that
> > will not give me these problems ?
> > 
> > I think that some of you use Proxxon products 
> > any pros\cons ?
> > 
> > Look forward for any comments
> > 
> > Howard
> 
> Proxxon TBM 220
> 
> -- 
> Best Regards,
> Zoran A. Šćepanović
> zastos@...
> http://zastos.com
> +381 63 609-993
> 
> -..-
> If a program is useful, it will have to be changed.
>