Hi All
Am having some probs with my drill\stand setup.
The stand is the type with a single slide piller,
it is meant for a 240v work drill (i use a dremel drill )
sometimes the stand will move from side to side and
snap the drill bit !!.
Can anyone suggest a good drill\stand combination, that
will not give me these problems ?
I think that some of you use Proxxon products
any pros\cons ?
Look forward for any comments
Howard
Am having some probs with my drill\stand setup.
The stand is the type with a single slide piller,
it is meant for a 240v work drill (i use a dremel drill )
sometimes the stand will move from side to side and
snap the drill bit !!.
Can anyone suggest a good drill\stand combination, that
will not give me these problems ?
I think that some of you use Proxxon products
any pros\cons ?
Look forward for any comments
Howard