Homebrew PCBs

On Fri, 13 Apr 2012 02:55:27 -0000, you wrote:

>Hello all, the green film from Pulsar - what is the best temperature to run it thru laminator?  I ran thru at 370\ufffdF and that "seemed" like it "might" be a tad hot.  It sorta "smeared" on a couple of close traces and I had to use a probe to clean before etching.

"foil" setting, no idea of temperature.  Run it twice.  I have a
similar problem at times, but I've also had the film simply not
adhere, regardless of temperature.

You want to see an absolutely clear area where there used to be green.

On the other hand, it saves more boards than it ruins....

Harvey

>
>Only 1 time thru?
>
>Thanks to all for any info,
>
>Ken H>