Homebrew PCBs

I had not considered about the issue with small boards - I would expect the rollers to be at least an inch or so apart?  That would allow a board of at least 2"X3" to work....  maybe?  BUT I have done a couple of boards less than 2" square...  Hmmm, might be a problem.

I would like to hear from someone who has used one.

Thanks for the caution.

73 de Ken H>

--- In Homebrew_PCBs@yahoogroups.com, "tda7000" <Tda7000@...> wrote:
>
> Most toner only needs 170°C, this one can go to 200°C, don't see why it wouldn't work...
> 
> The 4-roller thing has me worried a bit though, depending on how far apart they are it might be possible for a rather small board to get stuck inside...
> 
> --- In Homebrew_PCBs@yahoogroups.com, "sailingto" <sailingtoo@> wrote:
> >
> > Has anyone used the Apache AL13P Professional 13" wide laminator?  It's got 4 rollers, a digital temp readout up to 393ºF, and $80 shipped from below:
> > 
> > http://tinyurl.com/3pa3mfs
> > 
> > There is also an Amazon site selling for same price shipped.
> > 
> > Comments anyone?
> > 
> > 73 de Ken H>
> >
>