Homebrew PCBs

Yes I do the same see this youTube video http://youtu.be/7I41tVOruug
groundplane on both sides
if you like please subscribe




________________________________
From: Terry <twgray2007@...>
To: Homebrew_PCBs@yahoogroups.com
Sent: Wed, April 6, 2011 9:52:40 PM
Subject: [Homebrew_PCBs] Re: ground planes - two sides, or just one?

  
Generally speaking, the more ground plane -- top and bottom -- the better.  The 
last step in most of my designs is to do a polygon fill tied to GND on both 
sides of the board.

--- In Homebrew_PCBs@yahoogroups.com, "Andrew" <a_wake@...> wrote:
>
> I am closing in on designing a board that is a mix of SMD and through hole 
>parts. I am using a zone on the bottom side to provide a ground plane; I 
>wondered about adding a zone to the top as well. If I did a top zone, is there 
>any reason I can't make it a ground plane as well?
>


 

[Non-text portions of this message have been removed]