Homebrew PCBs

It is easy to see in the video that the board you are cutting is sliding
UNDERNEATH the rip fence.  That's the problem.
Mark

On Fri, Mar 18, 2011 at 3:08 PM, Alessio Sangalli <alesan@...>wrote:

>
>
> On 03/18/2011 09:31 AM, Andrew Volk wrote:
> > NEVER, NEVER, NEVER free hand cut anything on a table saw! Always use a
> > fixed fence set parallel to the blade (clamp a piece of wood to the top)
> or
>
> Why do people even think I have not used read the manual:
>
> http://manuals.harborfreight.com/manuals/3000-3999/3733.pdf
>
> Or done a free hand cut without the "fence"; here the video of what I did:
>
> http://www.youtube.com/watch?v=MG61de0io6Q
>
> bye
> as
>
>  
>


[Non-text portions of this message have been removed]