Homebrew PCBs

On Fri, Mar 18, 2011 at 2:08 PM, Alessio Sangalli <alesan@...> wrote:
> On 03/18/2011 09:31 AM, Andrew Volk wrote:
>> NEVER, NEVER, NEVER free hand cut anything on a table saw!  Always use a
>> fixed fence set parallel to the blade (clamp a piece of wood to the top) or
>
>
> Why do people even think I have not used read the manual:
>
> http://manuals.harborfreight.com/manuals/3000-3999/3733.pdf
>
> Or done a free hand cut without the "fence"; here the video of what I did:
>
> http://www.youtube.com/watch?v=MG61de0io6Q
>
> bye
> as
>

It does look like the board is going under the fence while you are
cutting.  You had cut the video but it appears that you did not check
to see if the fence was parallel to the blade first either.

-- 
Erik L. Knise
Seattle, WA