Homebrew PCBs

you should have a guide attached you your table saw to prevent x-Axis slips.

On Fri, Mar 18, 2011 at 3:47 AM, David C. Partridge <
david.partridge@perdrix.co.uk> wrote:

>
>
> You need to use the cutting guide - read the instructions
>
> Regards,
> David Partridge
>
>
> -----Original Message-----
> From: Homebrew_PCBs@yahoogroups.com [mailto:Homebrew_PCBs@yahoogroups.com]
> On Behalf Of Alessio Sangalli
> Sent: 18 March 2011 07:17
> To: Homebrew_PCBs@yahoogroups.com
> Subject: [Homebrew_PCBs] Table saw
>
> Hi finally tonight I tried the table saw (Harbor Freight one) with the
> lopacki 8mil diamond blade.
>
> Unfortunately, all cuts were not parallel:
>
> http://www.manoweb.com/alesan/temp/tablesaw/test01.jpg
> http://www.manoweb.com/alesan/temp/tablesaw/test02.jpg
>
> Advices? I read I might have to go slower... will that do the trick? I used
> it wet. A bit splashy but no dust at all.
>
> bye
> as
>
> ------------------------------------
>
>
> Be sure to visit the group home and check for new Links, Files, and Photos:
> http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>  
>


[Non-text portions of this message have been removed]