Homebrew PCBs

DJ Delorie pravi:
> I have a green kitchen scrubbie and some Dawn dish detergent.  I scrub 
> them a bit to get dirt and debris of them, and make them basically 
> shiny, but I use UV film so it's not as critical that it be clean at the 
> atomic level :-)
>
>   
Again Mee.
I use Green kitchen scrubbie too. But this time dry! No solvent's at all.
And I newer lost a trace.
To make job easy I cut aprox 8cm diameter disc from scrubby and make few 
discs. Then I punch hole in the middle and stack that to the M8 bolt. 
After screw all together I just put that to the drill machine and turn 
it on at low to moderate speed. And just jittle pushing the board 
against that clean it pretty well. The 10cm X 8cm board cleaning time is 
under 30 seconds.

Cheap easy and not stinkable.

Slavko.