Homebrew PCBs

The Pulsar site states that .062 will work but requires a push on the
board as it goes in and pull as it comes out, otherwise the motor will
not move the board very easily.

 

 

 

Best Regards,

Steve Maroney

 

Business Computer Support, LLC

Mobile Phone:504-914-4704

Office Phone: 504-904-0266

Fax: 866-871-7797

 

 

From: Homebrew_PCBs@yahoogroups.com
[mailto:Homebrew_PCBs@yahoogroups.com] On Behalf Of sailingto
Sent: Wednesday, July 28, 2010 11:51 AM
To: Homebrew_PCBs@yahoogroups.com
Subject: [Homebrew_PCBs] Re: New GBC H65

 

  

I have the H-65 laminator and it handles .062" PCB material ok - by
beveling the edges of PCB material it works just fine.

Without beveling sometimes a tad extra push is required to start the PCB
into rollers, and they will "pop" a bit as the board exits the rollers,
but doesn't seem to hurt anything.

I normally use .032", but do use .062" anything I need extra thick
board, or if that's all I have.

Ken H>





[Non-text portions of this message have been removed]