Homebrew PCBs

Maybe you could find a place where you could permanently store your etching
container, filled.
I put mine in a plastic box that can catch all the etchant (in case of a
spill), and covered the whole thing with another plastic box of the same
dimensions, as a lid. Keeps the dust out. The etchant container itself has a
cover too. None of the covers are air tight, but that doesn't seem to be a
problem. Keeping air exchange down with some kind of lid is enough.

ST

On Mon, May 31, 2010 at 7:50 PM, Alessio Sangalli <alesan@...>wrote:

> Hi, I have yet to find a suitable container for the etchant (I use the
> muriatic acid thing).
>
> It is true I can use any sort of plastic container: I even have one of
> those kits, with acquarium pump and bubbler and heater, but the main
> problem is that it is basically impossible to store safely, as it cannot
> be properly sealed. Pouring back to another, safer container can be
> still be problematic because of spills and such, and then I always have
> to wash everything, that takes time to do properly. Also, as I never do
> boards bigger than the standard 10x16 cm, I feel like a smaller
> container with "not so much" etchant would be so much better for my needs.
>
> Any advice?
>
> I have reached a point in my PCB making that I can do very fine boards,
> no problem, but I waste a lot of time in taking care of details, and I
> want to make the whole thing more streamlined.
>
> bye
> as
>
>
>
> ------------------------------------
>
> Be sure to visit the group home and check for new Links, Files, and Photos:
> http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>
>
>


[Non-text portions of this message have been removed]