There are two answers to this question.
1) Manually route, and just do so one the desired side of the board. I usually manually route most if not all of the traces on my boards; I'm rarely if ever satisfied with what the auto-routers come up with.
2) Tell KiCad that your board is single layer only -- in PCBnew, click on Preferences, then on General. Click on the desired number of layers (1 in this case). Click okay, and you are good to go.
1) Manually route, and just do so one the desired side of the board. I usually manually route most if not all of the traces on my boards; I'm rarely if ever satisfied with what the auto-routers come up with.
2) Tell KiCad that your board is single layer only -- in PCBnew, click on Preferences, then on General. Click on the desired number of layers (1 in this case). Click okay, and you are good to go.
--- In Homebrew_PCBs@yahoogroups.com, "acidblue" <sunblaster5@...> wrote:
>
> How do I get Kicad to make traces just on one side of the PCB?
>