Homebrew_PCBs

p

Sent from my HTC Touch Pro2 on the Now Network from Sprint�.

-----Original Message-----
From: Frank P <qz9090@...>
Sent: Monday, May 10, 2010 11:53 AM
To: Homebrew_PCBs@yahoogroups.com <Homebrew_PCBs@yahoogroups.com>
Subject: [Homebrew_PCBs] Re: Best Way to Cut PCB



I wonder if MicroMark sells small table saws?

--- In Homebrew_PCBs@yahoogroups.com <Homebrew_PCBs%40yahoogroups.com>,
"sailingto" <sailingtoo@...> wrote:

>
> Harvey, you are correct - the PCB section that is cut off does not do well

at all, unless it's pretty large - couple of inches maybe?

>
> Most all my boards are at least 1" to 3" in width, and that tends to cut

off pretty good, but cutting a thin slice will just curl.

>
> If I had to do 15 or 20 boards I think I might opt for a table saw myself

- being sure to use a very fine tooth carbide blade.

>
> In the PCB cutoff thread last week there was a really nice looking tiny

table saw using diamond blade that looked like it'd do the trick.... If I
needed 20 boards I think I'd seriously consider looking at a commercial
offering.

>
> Ken H>
>

[Non-text portions of this message have been removed]