Homebrew PCBs

Does the paper cutter warp the piece of PCB that you cut off? Just 
wondering if both sections that result from a cut remain flat?

Steve

On 4/20/2010 8:35 PM, sailingto wrote:
> Those are nice bandsaws - but sure seem a bit of "overkill" for tiny little PCB - well, my boards anyway are always less than a 4"X6" size.  I use the HF paper cutter - cheap, and does a good job on anything up to .062".
>
> This is the one I have:
>
> http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=90874
>
> it was on sale, but thinking about getting this larger one:
>
> http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=90874
>
> $20USD vs $25USD isn't much difference.  When I purchased my paper cutter at HF I think there was over $10 difference.
>
> Ken H.
>
> --- In Homebrew_PCBs@yahoogroups.com, Steve<steve65@...>  wrote:
>    
>> Thank you. There's a Harbor Freight nearby, I'll take a look.
>>
>> Steve
>>
>> On 4/18/2010 9:24 PM, awakephd wrote:
>>      
>>> Steve, Home Depot does not carry these, to the best of my knowledge, nor does Lowe's. Instead you need a Harbor Freight or similar store:
>>>
>>> http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=93762
>>>
>>>        
>
>
>
> ------------------------------------
>
> Be sure to visit the group home and check for new Links, Files, and Photos:
> http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>
>
>
>    

-- 
Read The Patriot Post    Vertitas vos Liberabit
http://patriotpost.us/subscription/