Homebrew PCBs

WOW!!!  Bob, you sure do come thru everytime I'm in a lurch!  I just hope I can repay in kind someday.....  AND that dinner invite is ALWAYS open for some good Gulf Coast Shrimp... or maybe boiled crawfish?

Thanks,

Ken H>


--- In Homebrew_PCBs@yahoogroups.com, Bob Huish <bhuish@...> wrote:
>
> To Ken
> 
> I might have some in the shop. I will try to get a picture off to you today.
> They are marked. :International Eyelets, Inc" F-4093-c, F-6093-c
> 
> Bob
> 
> 
> 
> On 1/27/2010 8:59 PM, sailingto wrote:
> > Is there any place to get just a few eyelets to test out?  Heck, even at 10 or 20 samples would keep me going for a while - I only make 2 to 4 boards/month - and each of those usually have 3 or 4 vias.
> >
> > Thanks for any guidance to a source.
> >
> > Ken H.
> >
> > --- In Homebrew_PCBs@yahoogroups.com, Leon Heller<leon355@>  wrote:
> >    
> >> On 27/01/2010 02:55, Terry Mickelson wrote:
> >>      
> >>> On 26-Jan-10, at 1:10 PM, Paul Mateer wrote:
> >>>
> >>> Keystone has them: http://www.keyelco.com/products/specs/eyeletspec.asp
> >>>
> >>> -Reply:
> >>>
> >>>
> >>>
> >>> Sorry, no good. A wide flange eyelet is useless for dip packages
> >>> because their flanges would overlap each other. Are there any other
> >>> sources that don't insist on UPS and their extra charges?
> >>>        
> >>
> >> Try Multicore Copperset:
> >>
> >> http://www.prime-electronics.com.au/datasheets/data/Multicore/Wave%20Soldering/Acessories/Through%20Hole%20Repair%20Kit/Tech%20Data%20Sheet.pdf
> >>
> >> The kits are expensive, though.
> >>
> >> Leon
> >>
> >>      
> >
> >
> >
> > ------------------------------------
> >
> > Be sure to visit the group home and check for new Links, Files, and Photos:
> > http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
> >
> >
> >
> >
> >
>