Homebrew PCBs

That, combined with your tools and skill.

What's the recommended trace width: LARGE
What's the recommended spacing: LARGE
What's the recommended pad size: LARGE

In short, put as much copper down as you can. Trace width/spacing is
usually best near a 1:1 ratio for signal traces (e.g. 10mil trace
10mil distance).

Start with _at least_ 10 mil traces and 1mm restring around the holes,
more if you have the space.

ST

On Mon, Dec 21, 2009 at 3:06 PM, blalor76 <blalor@...> wrote:

> Ok, so taking the etching method out of the equation, I still need to drill out the holes without ripping them up.  Is that just a function of the size of the annular ring?
>
>