sonds much like the HF press is only a "heavy stand" then?
if you have to add the bearing shafts etc...
i think you could attach a lever for operating it and get rid of the
original press?
i am sure i am wrong but i only want you to figure this out more detailed
;-) .
if anyone wants to see some drill press samples look here:
http://www.megauk.com/cgi-
bin/mega/lp.pl?page=http://www.megauk.com/pcb_drilling_machines.php
i also think that it is not a good idea to use a full size drill press
(without that "use youe own spindle on some rail" method).
because it is far too slow.
i think 10000 to 20000 rpm is minimum...
regards
st
if you have to add the bearing shafts etc...
i think you could attach a lever for operating it and get rid of the
original press?
i am sure i am wrong but i only want you to figure this out more detailed
;-) .
if anyone wants to see some drill press samples look here:
http://www.megauk.com/cgi-
bin/mega/lp.pl?page=http://www.megauk.com/pcb_drilling_machines.php
i also think that it is not a good idea to use a full size drill press
(without that "use youe own spindle on some rail" method).
because it is far too slow.
i think 10000 to 20000 rpm is minimum...
regards
st