Homebrew PCBs

Boy Andy - Did DJ come thru with all the info to build his temperature controller? I was just browsing his link - that is everything there from BOM, PCB, with complete layout - including hole count for eVERY hole on the board... all 105 of them...  I'm not sure I can drill a .015 hole - that's tiny!

Even the software source is there.  I'm not sure I can figure all that out - I've only did a tiny bit with AVR chips.

Thank you DJ.

73 de Ken H>

--- In Homebrew_PCBs@yahoogroups.com, "awakephd" <a_wake@...> wrote:
>
> DJ, did you write the control program in C or in assembler? How would you feel about sharing the program? Please don't hesitate to say no -- I will certainly understand if there is anything proprietary or that you want to hold onto. I ask because I am getting ready to order a couple of R8C-27's to experiment with and would like to get some ideas about programming them.
> 
> Thanks,
> 
> Andy
> 
> --- In Homebrew_PCBs@yahoogroups.com, DJ Delorie <dj@> wrote:
> > Ok, ok, I'll take pictures ;-)
> > 
> > http://www.delorie.com/electronics/laminator/
> > 
> > The left button is units (F/C).  The right button is display mode:
> > temp, runtime, "time at temperature", and current duty cycle.  The big
> > black knob is the temperature setting.
> >
>