Homebrew PCBs

Have you checked the Links under "Plated Through Holes" yet? Not many
links there, but it is something. Markus Zingg's page on through hole
plating has been down for a while, but I just found where someone
mirrored it and put that link in place of the missing site.

http://tech.groups.yahoo.com/group/Homebrew_PCBs/links

If you find any other links on through-hole plating, please place them
there.

Steve Greenfield

--- In Homebrew_PCBs@yahoogroups.com, "Juan EA7FNJ" <esp7xx@...> wrote:
>
> Hi guys!
> 
> I'd like to make the vias of my board and I think the best method is
> electroplating. But, I was looking for some information about it, and
> I didn't find something that I can understand.
> 
> My question:
> 
> How can I make a good vias using electroplating? I was reading and I
> have some ideas: clean the copper side of my PCB, use an acid bath,...
> 
> But I don't know how many volts and amps to make it, concentrations... 
> 
> is there any good manual step-by-step?
> 
> Thanks.
>