I love Harbor Freight
From: Homebrew_PCBs@yahoogroups.com [mailto:Homebrew_PCBs@yahoogroups.com]
On Behalf Of pcb.easy
Sent: Friday, October 10, 2008 4:42 PM
To: Homebrew_PCBs@yahoogroups.com
Subject: [Homebrew_PCBs] Re: Cutting FR4
I have found and use a small 4" table saw from Harbor freight ITEM
93211-1VGA works really well for small (less than 12 square inch)PCBs.
The saw is often on sale in the store for $29. The saw comes with a
cheap blade that is not worth keeping! Go down to Home Depot and buy a
good carbide tip 4" blade, it will last a very long time. Remember
that the dust from cutting fiberglass is DEADLY, wear a good dust
resporator to protect your only set of LUNGS!
Ron
[Non-text portions of this message have been removed]
From: Homebrew_PCBs@yahoogroups.com [mailto:Homebrew_PCBs@yahoogroups.com]
On Behalf Of pcb.easy
Sent: Friday, October 10, 2008 4:42 PM
To: Homebrew_PCBs@yahoogroups.com
Subject: [Homebrew_PCBs] Re: Cutting FR4
I have found and use a small 4" table saw from Harbor freight ITEM
93211-1VGA works really well for small (less than 12 square inch)PCBs.
The saw is often on sale in the store for $29. The saw comes with a
cheap blade that is not worth keeping! Go down to Home Depot and buy a
good carbide tip 4" blade, it will last a very long time. Remember
that the dust from cutting fiberglass is DEADLY, wear a good dust
resporator to protect your only set of LUNGS!
Ron
[Non-text portions of this message have been removed]