Homebrew PCBs

Hi

Fair point.
I intend to make single sided pcb.
I am not sure of what I should buy, however equipment is not a problem.

I am looking for a method which will be very simple and not applicable to
mass produce.

I have never made a PCB, which of the methods will you suggest I should
start with(because it is very easy) ???

Regards
Gaurav

On Thu, Jul 24, 2008 at 11:52 PM, Myc Holmes <mycroft2152y@...> wrote:

>   There are many methods to create a pcb.
>
> Much depends on what equipment you have or are willing to buy and the
> amount
> of time you want to spend learning the technique and drilling the holes.
>
> Also, the method depends on what you want on yur pcb. Bare board, solder
> mask, compopnent legends etc.
>
> There is no "best" method, just the method you are comfortable with.
>
> The general methods are:
>
> Photgraphic,
> Toner Transfer,
> CNC Milling
> Hand drawn
>
> Sometimes, for a one-of project, poin tot point wiring, wire wrap or strip
> bopard works fine.
>
> Myc
>
> On Thu, Jul 24, 2008 at 12:24 PM, gaurav_verma_mca <
> gaurav.verma.mca@... <gaurav.verma.mca%40gmail.com>> wrote:
>
> > Hi
> >
> > I have tried many sites on creation of PCB and each gives a new
> > technique.
> >
> > I have software which will create my PCB design but after that there
> > are so many methods some say to trace it other say use a printer and
> > then transfer it to PCB using an electri iron....
> >
> > Which method is good which is bad.
> >
> > Please note that I am looking at making one PCB for a given circuit
> > only. I will never do any mass production... which technique should I
> > use.
> >
> > Any help will be highly appriciated.
> >
> > Thanks
> > Regards
> > Gaurav
> >
> >
> >
>
> [Non-text portions of this message have been removed]
>
> 
>



-- 
Gaurav Verma
Email - Gaurav.Verma.MCA@...
Phone - 9910732960


[Non-text portions of this message have been removed]