Homebrew PCBs

Do you have an exact reference for the HammerMill paper you use ?
I'm living in belgium and I would like to give it a try by ordering it
on the net.

Mike

--- In Homebrew_PCBs@yahoogroups.com, "rdheiliger" <rdheiliger@...> wrote:
>
> I use the HammerMill Office Glossy paper. I did a search on the web 
> and bought a 300 count package for less than $10 including shipping. 
> I have tried a lot of papers and this one is the best.
> 
> I use a toner transfer tool to do the transfer, see link below. This 
> works much better than a cloths iron. Iron untill the paper turns a 
> very light brown, and the pattern can be seen thru the paper. Pay 
> attention to the edges as this seems to be an area where the heat 
> disapates more rapidly. 
> 
> http://www.rockler.com/product.cfm?page=5734&filter=toner%20transfer
> 
> Instead of just soaking the paper off, I put the board and paper into 
> a pan of boiling water, and continue boiling untill the paper nearly 
> floats off. This takes less than 2 minutes. Then rinse under cold 
> water with a minor amount of rubbing to get the small fuzzy's off. 
> 
> I get nearly perfect transfers every time.
> 
> RD
>