Homebrew PCBs

I only have a dot matrix printer.  The way I use toner transfer 
technique is to print the circuit out on a plain sheet of paper, cut 
it out and pasted it to another sheet of paper.  Additional circuits 
are printed, cut out, and pasted until the paper is 
covered.   Different circuits can be printed out.  The goal is to 
cover the sheet of paper.  Take the circuit covered paper to a big 
box office supply store, e.g., Office Depot, etc.  and have the 
circuit covered paper copied to a toner transfer sheet.  Cost less 
than 10 cents.

Cut out the copy of the circuits on the toner transfer paper and 
"iron" them on the printed circuit boards.
At 07:42 PM 10/15/2007, you wrote:

>I never use whole sheets of TT paper.
>
>I print out the design on plain paper, cut out a TT swatch a little
>bigger than the board, tape it to the pre-printed plain paper, and run
>it through the printer again.
>
>One TT sheet can make many boards that way.
>
>
>Be sure to visit the group home and check for new Links, Files, and Photos:
>http://groups.yahoo.com/group/Homebrew_PCBs
>Yahoo! Groups Links
>
>
>

         73,
         Mike, K4GMH 

[Non-text portions of this message have been removed]