Homebrew PCBs

--- In Homebrew_PCBs@yahoogroups.com, Mark Brueggemann <qrq_cw@...> 
wrote:
> I use a Quickcircuit at work, and I've never had any luck running
> stub endmills any smaller than 8 mils into 1oz board, no matter what 
> the feed rate. 
> Mark B.
> Albuquerque, NM
>

Could you expand on that? What kind of troubles did you have?

I could probably do evetything with a 30 degree v-bit that I need but 
if the boards aren't perfect (few are) then the really fine pitch stuff 
is hit and miss. A tiny bit of a warp in the board can cause over or 
undercutting with a V-bit. The endmill is appealing in that trace width 
doesn't vary with depth.