Homebrew PCBs

Hi Guja,

Let me say that LJet stuff wasn't technically possible
when it appeared (mid 90's)

I used to register double sided for offset duplication
and I couldn't get it.

Trouble is the mechanism of the LJIV, as they weren't
prepared to 'register' precisely on both sides.

That could be work for the models being 'double-side
enabled' then corporate office printers of the mid
90's.

You'll ned to do some manual guide positioning system
for proper alignment.

Hope that helps.



  
Re: Laserjet 4 plus Problem !!!
Posted by: "guja" guja2001bg@...   guja2001bg
Mon Mar 26, 2007 2:03 pm (PST)

print them both at same time. ( two cdrs, side by
side)

Bruno St-Laurent <bsl88k@netscape. net> wrote: Hi guys
, i'm trying to print a PCB of 2.5 x 10.25 inches dual
layer ,
the print are proper lenght but the middle of the
print don't match(
offset) !!!! it seem that the printing is not linear
!!!

any of you have an idea ???

BSL


	

	
		
__________________________________________________ 
Pregunt\ufffd. Respond\ufffd. Descubr\ufffd. 
Todo lo que quer\ufffdas saber, y lo que ni imaginabas, 
est\ufffd en Yahoo! Respuestas (Beta). 
\ufffdProbalo ya! 
http://www.yahoo.com.ar/respuestas