Homebrew PCBs

On Sat, 06 Jan 2007 05:13:11 +0100, bentrods3500 <teecee@...> wrote:

> Perhaps ST can answere this with regards to the C84 do you think that
> it could be modified to use a Belt system to pull a table along
> (similar to the Print Head mechanism) I was thinking of mounting a
> small table under the print thats on a Linear Rail with bearings,
> they're very smooth.
> I'm off hunting for C84's & MISPro Ink's
> Thomas


The C84 may be strong enough for a lightweight table. If not i think it  
would be possible to take the stepper signals and amplify them for a  
larger motor.
Keep in mind that there is a calibration parameter that has to do with the  
torque on the paper feed motor, you can ajust it with the service utility.

ST