Stefan,
Lets see him produce plans without the window channel. The
window channel was my epiphany! He mounted the motor and bearing
plates on the channel the same way! The Z axis Gas pipe etc. I guess
if I stole your car and repainted it, that would be ok with you?
John
--- In Homebrew_PCBs@yahoogroups.com, "Stefan Trethan"
<stefan_trethan@...> wrote:
Lets see him produce plans without the window channel. The
window channel was my epiphany! He mounted the motor and bearing
plates on the channel the same way! The Z axis Gas pipe etc. I guess
if I stole your car and repainted it, that would be ok with you?
John
--- In Homebrew_PCBs@yahoogroups.com, "Stefan Trethan"
<stefan_trethan@...> wrote:
>has
> On Sat, 23 Dec 2006 22:37:19 +0100, crankorgan <john@...> wrote:
>
> > When he put the plans online that was no help. His comments and
> > the fact he introduced problems into the design. Brute has a stubby
> > 1-1/4" Z axis pipe. Dave Kush did things correctly only showing the
> > machine. He is a member of my group. Dave and I both changed the
> > Z-axis pipe within days to 1-1/4" pipe. When people give me
> > suggestions I am usually into another project or I have the update
> > done and I am testing it. The Brute was a NCF2000 then NCF2001 which
> > became PCBmill and then Brute. The free plans are a poor copy of the
> > PCBMill. At one point I had two PCBMills turning out milled Piker
> > boards. Then with some help from Hans here I got a PC house to make
> > the Piker boards.
>
>
> But are these _his_ plans, or _your_ plans?
> If he has copied them from you, i can understand your dissatisfaction
> about the whole thing, but if they are merely plans of a machine he
> built on his own, i don't see the probem?
>
> ST
>