Homebrew PCBs

Be VERY careful with the router.  Mine yanked the board out of my hand and scared the heck out of me.
I'm not doing that again.  I didn't have a large enough board to hold on to.

  ----- Original Message ----- 
  From: DJ Delorie 
  To: Homebrew_PCBs@yahoogroups.com 
  Sent: Wednesday, December 13, 2006 4:43 PM
  Subject: Re: [Homebrew_PCBs] Re: Wooden CNC router



  I have a standard X-Acto paper cutter that works (barely) for 0.031"
  FR4.

  Normally, I use #2 scroll saw blades on 0.062, which are good for
  about a foot or two before they need to be replaced. Fortunately,
  they're cheap. Next time I'm at the store, though, I'm going to pick
  up a v-scoring bit and see how that works out on my router table.


   

[Non-text portions of this message have been removed]