On Wed, 02 Aug 2006 10:20:42 +0200, Bill Westfield <westfw@...>
wrote:
The only single-sided material i have is 0.5mm or maybe 1mm.
As you say it just isn't used so much in PCB shops.
I think there should be large amounts of "cheap" phenolic boards around,
single sided, like used in cheap televisions and lotsa other stuff. But
maybe those mass producers are so efficient they do not leave cutoffs ;-)
ST
wrote:
> but findingi just leave the second side blank and etch it away as well.
> single-sided material is quite a pain.
The only single-sided material i have is 0.5mm or maybe 1mm.
As you say it just isn't used so much in PCB shops.
I think there should be large amounts of "cheap" phenolic boards around,
single sided, like used in cheap televisions and lotsa other stuff. But
maybe those mass producers are so efficient they do not leave cutoffs ;-)
ST