Homebrew PCBs

>Using Shellac as a coating may not be good when SMD is involved but
>is fine for single sided through hole boards.

Just about any spray could work for single sided through hole boards 
provided it was applied **after** soldering. I used to use Phenolic 
boards, Cool-Amp (silver coating) and Krylon clear spray, here is an 
example;

http://www.pbase.com/eldata/image/63450959

The Cool-Amp wasn't necessary but the silver coating looked better 
than bare copper. Why would you want to apply the Shellac before 
soldering for single sided through hole boards?

--- In Homebrew_PCBs@yahoogroups.com, "warrenbrayshaw" 
<warrenbrayshaw@...> wrote:
>