Homebrew PCBs

Hi Don,

    I use Eagle and Press -N- Peel. I first print out the output of Eagle on a standard sheet of paper. I then cut a piece of Press-N- Peel slightly larger than the output and tape it lightly over the output on the paper and feed it back through the printer. Works great and no waste of Print-N- Peel.

     Hope that  this works for you - Jack
  ----- Original Message ----- 
  From: Dell Gillispie 
  To: Homebrew_PCBs@yahoogroups.com 
  Sent: Sunday, April 13, 2003 7:12 PM
  Subject: [Homebrew_PCBs] Eagle Software Users


  Hi:

  I am attempting to make a couple boards using Eagle software and Press-N-Peel.  

  The smallest paper that I can feed my printer is 3" X 5".   Even at that size I could print at least two/three drawings per sheet of Press-N-Peel.  

  Is it possible to get the software multiple copies of the drawing per sheet of paper?

  Dell

  [Non-text portions of this message have been removed]


        Yahoo! Groups Sponsor 
       
       

  Be sure to visit the group home and check for new Bookmarks and files:
  http://groups.yahoo.com/group/Homebrew_PCBs

  To unsubscribe from this group, send an email to:
  Homebrew_PCBs-unsubscribe@yahoogroups.com



  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 



[Non-text portions of this message have been removed]