On May 19, 2006, at 10:21 PM, Robert Hedan wrote:
I was envisoning cleaning the board, popping hot glue dots on the
contact points, then spraypainting the board.
Afterward the glue dots will likely pop off leaving clean copper.
> Any reason why you couldn't let the poly remain and protect theYou'd need to at least clean off the contact areas.
> copper?
>
> Would it prevent you from soldering components, or would it melt
> away from
> the iron?
I was envisoning cleaning the board, popping hot glue dots on the
contact points, then spraypainting the board.
Afterward the glue dots will likely pop off leaving clean copper.