Homebrew PCBs

----- Original Message ----- 
From: "patroclus04" <patroclus04@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Thursday, April 13, 2006 8:42 PM
Subject: [Homebrew_PCBs] Another photo-resist PCB


> Hello,
> I made another PCB, this time more complex, and tried to solve the
> problems I had, especially the photo-resist coming out when tried to
> clean the board's surface while developing.
> I was not able to solve this...
>
> I'm thinking that may happend because of some light getting trough the
> dark areas in the transparency, so expossing a bit, and so making
> photo-resist come out when I try to clean the board while developing...
> If I take out the board and clean with lots of fresh water, then it
> does not come out anymore.
>
> Now the question... I don't know how to solve this. Maybe:
>
> - Less expossure time (the problem is I need 0.3mm track separation
> sometimes, so it's tricky, as little time doesn't allow to separate them).
> - Use acetate paper and laser printer (I was using inkjet paper,
> printing in the rough side with a inkjet printer. Should this be a
> problem??)
> - Take the board out of the developer sooner. When the image appears,
> I usually left the board in for about 1 or 1,5 minutes.
>
> Do you think this could be right?

The problem sounds like insufficient print density, you should be using the 
highest print quality available. On my Epson 870 I use the Photo Quality 
Glossy Film setting, with Mega Electronics JetStar film.

Leon
--
Leon Heller, G1HSM
leon.heller@...
http://www.geocities.com/leon_heller 

---
[This E-mail has been scanned for viruses but it is your responsibility 
to maintain up to date anti virus software on the device that you are
currently using to read this email. ]