Homebrew PCBs

Hello

i disagree for solder quality, very bad work. Cold solder, not enough solder, solder joint missing (lower side of the 2K2 resistor near the tantalum capacitor, left side of the board)

need a serious "touch-up" work before leaving factory

but photo quality is perfect. 

regards

Jacques


  ----- Original Message ----- 
  From: derekhawkins 
  To: Homebrew_PCBs@yahoogroups.com 
  Sent: Tuesday, April 11, 2006 8:04 PM
  Subject: [Homebrew_PCBs] Re: Through plating - double sided


  >What brand soldering paste?  And what process did you use to tin
  >the board?

  Search these archives on >plumber's solder paste<, discussion goes back 
  to around August 15, 2005. 

  >And what brand/model solder was it?  Those joints are beautiful, no 
  >ugly residue from rosin.

  Radio Shack, any rosin core solder should do, just use a toothbrush and 
  mineral spirits to clean off the residue.

  --- In Homebrew_PCBs@yahoogroups.com, Robert Hedan <robert.hedan@...> 
  wrote:
  >


[Non-text portions of this message have been removed]