Homebrew PCBs

Hi ?,

I've been looking in McMaster Carr.  Just not familiar enough with the 
parts.

It's a 12mm dia ACME thread.  Pitch is about .080", which is near 2mm, 
but not exact.  Inch is about 12.44, so I'm not sure what it is!

I keep looking.  The McMaster Carr prices are quite high!

Someone mentioned making an ACME tap from ACME threaded rod, maybe I'll 
try that.  With Delron or a similar material.

Another one I have is .375" and 16 TPI, but it's a little light.

Alan  KM6VV


scratch_6057 wrote:
> Alan Marconett
> 
> I'm still looking for flanged ACME
> bronze nuts and ACME threaded rods (to match some I have).
> 
> Try McMaster-Carr @ http://www.mcmaster.com/ start with the
> word "acme" in the Find Products box then select Acme Hex Nuts
> 
> This Link Might Work
> <http://www.mcmaster.com/param/asp/desc.asp?
> desc=Acme+Hex+Nuts&descid=1529&term=Acme+Hex+Nuts>
>