Homebrew PCBs

Hi Daryl,
--- In Homebrew_PCBs@yahoogroups.com, LogicResearch 
<logicresearch@...> wrote:
> With Eagle, how do you select a pad or object on the board you 
have just 
> routed and change it?
> The connections to solder components in are very small and I'd 
like to make 
> them bigger.

The easiest way would be to change the width of the trace.  If you 
want to have varying widths, use Ripup to delete the trace and Route 
to reroute.  Select the width you want for each segment.

> Looks like a good chunk of software if you can drive it.
> Also how do you force it to do single sided boards?

Set the preferred routing direction for the layer you don't want to 
use to N/A in Autorouter setup.

Regards,
Dennis