--- In Homebrew_PCBs@yahoogroups.com, "kilocycles" <kilocycles@...>
wrote:
I got to thinking about the upside-down iron and roller/crank again.
It hadn't occurred to me that the toner/paper side of the board would
actually be "sliding" across the aluminum plate (doh!). Probably a "no
go" now. It sucks too, because I removed some "gear wheel" off the
axle of the roller, and it had two nice holes in the flat side, and
recessed, hex-head set screws to hold it on, so it would've been easy
as crap to attach a handle to, as well as mounting the roller itself.
-George
wrote:
> I did a post on using Scotch 33+ electrical tapeTed, Thanks! I'll keep that in mind next time I need to do that.
I got to thinking about the upside-down iron and roller/crank again.
It hadn't occurred to me that the toner/paper side of the board would
actually be "sliding" across the aluminum plate (doh!). Probably a "no
go" now. It sucks too, because I removed some "gear wheel" off the
axle of the roller, and it had two nice holes in the flat side, and
recessed, hex-head set screws to hold it on, so it would've been easy
as crap to attach a handle to, as well as mounting the roller itself.
-George