Homebrew PCBs

On Thu, 09 Feb 2006 23:33:33 +0100, kilocycles <kilocycles@...>  
wrote:

> Well, I couldn't find the post to reply to that I read in my email
>
> digest, but I've found that the thinner PCB stock is ok for two-sided
>
> boards, and depending how it's going to be mounted, single-sided
>
> boards.  A .031 single-sided board that is foil-filled tends to curl a
>
> bit, at least one that had copper on both sides to begin with.
>
>
> Ted


I've seen the curling too on thin boards. i only use them for very small  
pcbs.
The single sided ones curl too.

ST