Homebrew PCBs

--- In Homebrew_PCBs@yahoogroups.com, "brewski922" <brewski@...> wrote:
>
> >  As stated in my post, the problem was that both of my irons didn't
> > reach the 200C (392F) toner fusion temperature anywhere on their
> > surfaces.  Given that they were two different irons of different
> > brands, I suspect that this might be a common problem.
> 
> What if you bypassed the thermostat in the irons?

A post elsewhere in this forum clearly pointed out to me that my iron
measurements were grossly inaccurate.  As someone else here stated
earlier, with an iron it's the _technique_ that's the potential
problem, not the heat.

Bill