Hi all,
I just went through the archives and found some folks using the GBC
Creative model laminator. About 2 years ago there were some talk
about using it, but no mention if there is a way to get to accept
thicker stock (1/32 works fine from what I have read so far).
Has anyone modified this to work with the thicker PCB material?
I did try to salvage a fuser from a laser printer, but I believe I
messed something up pretty bad as it won't heat. The condition it
was in (used) when I got was questionable to begin with so I am not
even sure it worked when I started with it.
Today, while at the local Target store, I see the GBC Creative
laminator on sale for $24.95 - I will buy one if it will work with
the 1/16" PCBs.
Thanks
Chris
I just went through the archives and found some folks using the GBC
Creative model laminator. About 2 years ago there were some talk
about using it, but no mention if there is a way to get to accept
thicker stock (1/32 works fine from what I have read so far).
Has anyone modified this to work with the thicker PCB material?
I did try to salvage a fuser from a laser printer, but I believe I
messed something up pretty bad as it won't heat. The condition it
was in (used) when I got was questionable to begin with so I am not
even sure it worked when I started with it.
Today, while at the local Target store, I see the GBC Creative
laminator on sale for $24.95 - I will buy one if it will work with
the 1/16" PCBs.
Thanks
Chris