Homebrew PCBs

Screwdrivers are built for low-speed and high torque, the exact opposite of 
what's needed for drilling small holes. It might be possible to set up a 
gear drive using the hex drive, but that still leaves the problem of 
coupling to the chuck.

----- Original Message ----- 
From: <pinoy_nyc@...>

>  I bought this stand since I thought I can use my power screwdriver to 
> drive
>  the built in chuck, but I found out that the nose of the screwdriver is 
> hex,
> which wont be able to driver the built in chuck, which has a round 
> connector,
>  and assume you'll be connecting a drill chuck on top of it.
>
>  is there some kind of an adaptor (from hex to round) so I can use my 
> power screwdriver to drive the built in chuck?...
>
>  I hope you understand what I'm saying.