Yahoo Groups archive

Homebrew PCBs

Index last updated: 2026-04-09 22:20 UTC

Message

[Homebrew_PCBs] plumbing paste not for SMD reflow

2005-11-22 by Stefan Trethan

I tried the paste for SMD out of curiosity, and found it is no good.
It will "melt" before reflow (the flux i think). The paste will flow all  
over the place, resulting in too little paste at the pad when finally  
reflowing. also the flux might be a problem later on.

Real SMD paste will stay a paste all the way.

ST

Attachments

  • No local attachments were found for this message.

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.