Homebrew PCBs

----- Original Message ----- 
From: "matt clement" <buckeyes1997@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Saturday, October 29, 2005 12:50 AM
Subject: [Homebrew_PCBs] aligning 2 layer boards?


> What is the best way to align side two before etching both sides?  I
> cant seem to get them to light up no matter what i do.
>
> My only thought was to etch one side while coating the second side in
> resist.  Once the first side is etched drill a few holes and then use
> them to align the second side?

I align the two transparencies and make them into a sort of envelope with 
masking tape. It works quite well, but the alignment isn't perfect.

Leon
--
Leon Heller, G1HSM
leon.heller@...
http://www.geocities.com/leon_heller 

---
[This E-mail has been scanned for viruses but it is your responsibility 
to maintain up to date anti virus software on the device that you are
currently using to read this email. ]