Hans,
Can you describe more about your Harwin Via Pins? I'm very interested.
Where did you get them, how much do they cost, what size holes do you drill,
how do you apply them, etc. Your board looks very nice!
*Brian
-----Original Message-----
From: Hans Wedemeyer [mailto:hans@...]
Sent: Friday, October 18, 2002 5:00 PM
To: Homebrew_PCBs@yahoogroups.com
Subject: Re: [Homebrew_PCBs] Ferric chloride?
COS (change of subject) for those interested I posted a photo of how I
rivet Harwin via pins
http://hans-w.com/pcb_harwin_rivets.jpg
<http://hans-w.com/pcb_harwin_rivets.jpg>
The four pads at the lower right are half of an SO8, should help to
gauge size.
Hans Wedemeyer
[Non-text portions of this message have been removed]
Can you describe more about your Harwin Via Pins? I'm very interested.
Where did you get them, how much do they cost, what size holes do you drill,
how do you apply them, etc. Your board looks very nice!
*Brian
-----Original Message-----
From: Hans Wedemeyer [mailto:hans@...]
Sent: Friday, October 18, 2002 5:00 PM
To: Homebrew_PCBs@yahoogroups.com
Subject: Re: [Homebrew_PCBs] Ferric chloride?
COS (change of subject) for those interested I posted a photo of how I
rivet Harwin via pins
http://hans-w.com/pcb_harwin_rivets.jpg
<http://hans-w.com/pcb_harwin_rivets.jpg>
The four pads at the lower right are half of an SO8, should help to
gauge size.
Hans Wedemeyer
[Non-text portions of this message have been removed]