Homebrew PCBs

to me, pid controlled laminator is an unbeatable solution.


  ----- Original Message ----- 
  From: mikegw20 
  To: Homebrew_PCBs@yahoogroups.com 
  Sent: Monday, October 17, 2005 8:01 AM
  Subject: [Homebrew_PCBs] Ideas (stupid??) for toner transfer


  Helo all.

  I just had a few random thoughts about toner transfer and I wondered if 
  anyone has tried them.  I am using an iron with a good level of success 
  as the boards I am using are quite small.  However, I read that many 
  people prefer the laminator to supply heat and pressure.  

  So I was letting my mind wander with heat and pressure and the thought 
  about sandwich presses (obviously you would need a flat plate) and 
  shirt iron presses (I am not sure of the proper name but the things 
  that iron a whole shirt in one pull of the handle)?  The disadvantage 
  would be the size, but both would require no modification unlike some 
  laminators.

  Has anyone tried either of these two?

  Mike





  Be sure to visit the group home and check for new Links, Files, and Photos:
  http://groups.yahoo.com/group/Homebrew_PCBs

  If Files or Photos are running short of space, post them here:
  http://groups.yahoo.com/group/Homebrew_PCBs_Archives/ 



  SPONSORED LINKS Electrical engineering degree online  Electrical engineering degree  Printed circuit board  
        Electrical engineering  Electrical engineering course  Electrical engineering graduate school  


------------------------------------------------------------------------------
  YAHOO! GROUPS LINKS 

    a..  Visit your group "Homebrew_PCBs" on the web.
      
    b..  To unsubscribe from this group, send an email to:
     Homebrew_PCBs-unsubscribe@yahoogroups.com
      
    c..  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 


------------------------------------------------------------------------------



[Non-text portions of this message have been removed]