Synth-DIY Yahoo! Groups Archives

Thread

Re: LCD flat panel for CMI series 3 / MFX-2

2009-10-08 by linear226@excite.com

Hi James,

I used to run an NEC Multi-Sync 15 inch which worked fine on my MFX. I heard of incompatibility even with these on the larger screen sizes though. Peter Weilk would know for sure, he was involved in a lot of troubleshooting on the MFX 2 as I'm sure you know.

Cheers Tony

--- In Fairlight-CMI@yahoogroups.com, James Thomson <jamesthomson@...> wrote:

Show quoted textHide quoted text

>
> Hi,
> 
>  Does anyone know which LCD TFT flat panel monitors will display all of the
> vertical information from a CG-3 graphics card installed in an MFX-2 ? I
> have the VGA CG-3 graphics option in my MFX-2's. All the flat panels I have
> tried are missing some of the vertcal information. Many thanks.
> 
> James Thomson
>

LCD flat panel for CMI series 3 / MFX-2

2009-10-08 by James Thomson

Hi,

 Does anyone know which LCD TFT flat panel monitors will display all of the
vertical information from a CG-3 graphics card installed in an MFX-2 ? I
have the VGA CG-3 graphics option in my MFX-2's. All the flat panels I have
tried are missing some of the vertcal information. Many thanks.

James Thomson

Re: [Fairlight-CMI] LCD flat panel for CMI series 3 / MFX-2

2009-10-08 by Martin Selwood

Hi James,

Try looking at the NEC Mutisync monitors, most of those allow re-scaling of the image (do check the manuals online before ordering one though because not all of them can).

We bought a brand new one for work recently to display a vga camera image but it was being stretched. It was 17" (I don't have the model number to hand) and it was about £160/£170 from Insight. I tried one of my old NEC 1850E's out to see if it would solve the problem and it did.

Cheers, Martin

Show quoted textHide quoted text

From: James Thomson
To: "Fairlight-CMI@yahoogroups.com"
Sent: Thursday, 8 October, 2009 16:17:10
Subject: [Fairlight-CMI] LCD flat panel for CMI series 3 / MFX-2

Hi,

Does anyone know which LCD TFT flat panel monitors will display all of the
vertical information from a CG-3 graphics card installed in an MFX-2 ? I
have the VGA CG-3 graphics option in my MFX-2's. All the flat panels I have
tried are missing some of the vertcal information. Many thanks.

James Thomson