Doepfer

Hi all,

I'm offering a range of generic front panels to go with my prototyping kits. Thaw are fully drilled and have fixing slots rather than holes to match either Doepfer or Asys racks. These are available on my blog on 4hp and 8hp sizes on 2mm grained clear anodized aluminium. This engraving service could be a really good way of completing the panels. Would you accept to do panels on an 'engraving only' basis? Could be a good complementary service!!

Please see http://synovatron.blogspot.com

Cheers
Tony

Sent from my iPhone

On 7 Mar 2011, at 13:17, "Julian" <julian@port23.net> wrote:

>>What widths do you have?

Hi David,

They are listed on the page, but, in case you cant see it (at work etc) -

Matt Blue12hp
Matt Blue12hp
Matt Blue10hp
Matt Blue10hp
Matt Blue10hp
Matt Blue10hp
Matt Black8hp
Gloss Blue8hp
Gloss Blue8hp
Gloss Blue8hp
Gloss Blue4hp

I have a load of silver somewhere also, but i will have to dig them out. I guess this was partially 'testing the water' to see if 
it was a popular concept / if the pricing was resonable / etc. I think the other companies charge about GBP 25 for a 4hp panel - 
even my12hp (3x as wide) that ive listed above are priced at less than that : )

(but, its not quite like for like, as, you would have to drill all but the mounting holes yourself, but most DIY sorts will find 
that easy enough)

The idea is for it to be a quick and cheap service, but, obviously, if i start charging too little, it would get to the point where 
i should do somthing else instead!

Julian 




[Non-text portions of this message have been removed]