hi tom, by comparing my moded and unmoded a155's i saw that the moded a155's really can be clocked even from saw waves and run normally(that's a bad thing,isn't it???)and,also they step correctly when you manually step them with the step button,not as the unmoded a155 do... bakis. --- Tim Stinchcombe <timothy@tstinchcombe.freeserve.co.uk> wrote: > Hi Bakis, > Thanks for the info. > > > if the mod is a resistor and a capacitor in the > a155 > > control board,then this is the mod i was telling > you > > about...it's the mod for letting you clock the > a155 > > from an imperfect clock pulse(with not sharp > > edges).also,with this mod ,you can step manualy > the > > This is part of what I was after - there is also a > wire from the > control board to the trigger board (it inhibits trig > 1 and 2 under > some conditions), and I was wondering if they were > both part of the > cure for some problem. However, that you say the res > & cap were to > help it with poor clock pulses raises a few > questions. I wondered if > it was for something like this, so I ran a quick > simulation of that > part of the circuit, and got the distinct impression > that it actually > made things *worse*, which made me think it was for > some other > purpose, and that if it was then hopefully the > degradation of the > clock pulse would still be acceptable! (The > simulation _did_ show > that the clock stops running at some point due to > the mod, and tied > in very closely with my measured value - around > 800Hz.) I shall look > at the circuit some more, I may be able to figure it > yet! > > Tim > > > > sequencer from the tiny step button more > > properly(without almost jumping > > steps...).but,also,this mod stops the a155 from > > running in high audio frequencies!even if you > clock > > the a155 from an a110 you will notice that,the > a155 > > can't run above a certain speed limit(which is > rather > > low!)all these are valid only if we're talking > about > > the same mod,though.... > > by the way,i removed this mod from two of my > a155's > > because i want them to be graphic vco's too! > > bakis. > > > ===== synthfreak(parallel worlds) athens-greece [Doepfer_a100] group owner-moderator __________________________________________________ Do you Yahoo!? Yahoo! Web Hosting - establish your business online http://webhosting.yahoo.com
Message
Re: [Doepfer_a100] Re: A155 factory-fitted revision
2003-03-13 by Bakis Sirros
Attachments
- No local attachments were found for this message.