Am 23.07.2015 um 22:04 schrieb 'Scott
Rogers' scott@scottfromcanada.com [Doepfer_a100]:
I highly recommend a condenser mic to use with it though. At first I was using my Shure 58 but then I got an AT2020 and suddenly all speech became crystal clear.A good microphone is good for sure, but more important is the "pre-treatment" of the microphone signal before you send it to the vocoder. I recommend for voice the following signal chain
preamp->multiple->EQ->compressor->noisegate->vocoder(modulator-in)
| /
multiple------------>ng-sidechain
The EQ should increase the range between 800Hz and 3000Hz, the low end (below 100Hz) should be dropped.
Florian