Doepfer

That's great Guy, although I was hoping for a bit more variety in the
outputs ;o)
 
David
 
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* * *
David Salter
Senior Consultant
SSG UKI

Thomson Reuters

O +44 (0)20 7542 2402X 52402
M 07990562402

david.salter@thomsonreuters.com
thomsonreuters.com <http://thomsonreuters.com/> 
 
P Please consider the environment before printing this e-mail 

 

________________________________

From: Doepfer_a100@yahoogroups.com [mailto:Doepfer_a100@yahoogroups.com]
On Behalf Of Guy
Sent: 16 February 2010 10:50
To: Doepfer_a100@yahoogroups.com
Subject: [Doepfer_a100] Re: A160-2 poll


  


A very quick sketch shows it's possible, although you might run into
panel-estate problems with three two-digit numbers:

http://www.guyd2.com/stuff/doepfer_div.jpg
<http://www.guyd2.com/stuff/doepfer_div.jpg> 

The sketch also shows that you save (shave) some points by using a
straight bar instead of a backslash.

_g

--- In Doepfer_a100@yahoogroups.com
<mailto:Doepfer_a100%40yahoogroups.com> , <yahoo@...> wrote:
>
> > If you'd opt for a three-position switch, then you could easily
> > label the divisions next to the output jacks in three columns, like
so:
> >
> > 2/3/3
> > 3/5/5
> > 4/6/7
> > etc...
> >
> > ...or similar.
> 
> Take a look at the A-160 front panel. There is not much space left for
the
> printing - unless the width of the panel is increased to 6 HP or we
use a 3
> point font :-)
> 
> Best wishes
> Dieter Doepfer
>






This email was sent to you by Thomson Reuters, the global news and information company.
Any views expressed in this message are those of the individual sender, except where the sender specifically states them to be the views of Thomson Reuters.



[Non-text portions of this message have been removed]